Revolutions Control

Thanks to this control module, the constant adjusting of the motor speed potentiometer becomes superfluous. You enter your revolutions, e. g. 540 revolutions of the power take-off, into the potentiometer and drive out of the field. Normally, you would need to adjust the potentiometer to the max. speed now. With this module, however, you only need to set the switch to "MAX" and you will achieve the full motor speed again. Go to the next field, turn the switch back and the motor speed gets reduced to the originally on the potentiometer set value.

The module simply gets pinned on the original harness and the additional switch inserted into the switch control field and connected. The installation time amounts to 10 minutes only and can also be carried out by a layperson.

• • No more tiresome searching of the maximum motor speed
• • Simplification of the operation
• • Higher motoring comfort

The engine speed control i is "intelligent" and overtakes for you the permanent work of limiting the engine speed for power take-off machines. You feed the module with the motor revolutions for all three speed ratings of the rear power take-off (540, 540E, 1000 rpm). As soon as the rear power take-off gets activated via the switch or HMS, the engine speed control i changes to the engine speed you set. The motor speed can be adjusted in the command centre to the attachd machine at any time. Additionally, it is possible to programme a fourth motor speed which can be activated, respectively deactivated by the John Deere "Speed sensor".

This electronics is not a luxury, but a must for every John Deere premium tractor!!!
Ask your John Deere dealer!

• • No more tiresome searching of the maximum motor speed
• • Simplification of the operation
• • Higher motoring comfort
• • Enlargement of the John Deere HMS system